Clean water?
You are currently browsing comments. If you would like to return to the full story, you can read the full entry here: “Clean water?”.
Tagged with: calcium • clothes • faucets • google • home depot • plumbers • purification filter • red clay • red mud • script type • text javascript
Filed under: Water Filter System
Like this post? Subscribe to my RSS feed and get loads more!
Please don’t spend thousands on a softener or expensive reverse osmosis water filter. You can have a plumber install a simple sediment filter. If you want, you could install a sediment filter followed by a carbon filter if you have problems with an odd taste in your water. The least expensive but best brand is Cuno’s AquaPure (http://www.aquapure.com/problem/).
We routinely install them with great success. In fact, I have the same problem at my home. Typically the suspended solids are caused by your water provider’s storage tank running a bit low. When the massive pumps turn on to refill the tank, it kicks up sediment on the bottom of the tank.
sediment filter
Hi Brandon…
Well, to begin with, calcium is not red…it’s white…GULP…!
If it is a pinkish colour, it is obviously an algae caused by high humidity indoors or carried in thru your water.
I have stopped at rest stops in Georgia and have found reddish faucet water. Most certainly the water is safe to drink, despite the colour, or the health department would do something about it.
For the ultra fine powder of clay and calcium there is no inexpensive machine to correct the situation, believe me…been there…done that…! Even Sear’s best is not as "best" as they would have you believe.
I am in a high calcium area of Indiana and learned the hard way as you are now learning. I have researched every make of filtration system available as well as water softeners. Some work fairly well, some not at all. Others require too much maintainance and added cost of filters, salt and water usage.
My solution…buy a water softener…!!!
Which brand…Waterboss
Why… Waterboss is solid state…operates on 28 volts, uses only about 15 gallons of water per cycle, cycles on demand only (not on scheduled timing which adds a 1000 plus gallons to your water bill) and uses less salt pellets than all the others. The cost for one is average to $600.00 at Lowes. It is easy to install but should be set on a small platform and not on the cement floor. I use one bag of salt per month.
A water softener will not remove all the sediment in the water but it certainly will be better than beforehand. I installed mine in 1994 and have never had to service it as even loss of electricity or being away on vacation does not interrupt a "cycle on demand" machine. My children have followed suit with me and also have had no problems.
A mention of calcium…. Calcium is attracted to heat and will harden. If you have an electric hot water heater, the elements will build up with calcium and render them useless and raise your electric costs when doing so. The tank will fill with calcium and need replacement on average of six years span. Be sure to drain your water heater…gas or electric…once a month so as to flush out calcium buildup on the bottom.
As for bath fixtures…after you bathe, use your towel to wipe the fixtures clean each time and the usual chemical clean as normal is all that can be done. There is no solution cleaner that can replace damage already done to the fixtures.
Good luck…